Hello
I recently purchased a Tamiya Hornet kit and it is now fully built. I have had it running for about twenty minutes then whenever I put it in full throttle,either in reverse or forwards it starts jerking/losing signal and will not stop until you ease of the power. I have run through the set up procedure checked batteries connections etc and all things would point to either the TEU-101BK or the Acoms transmitter-receiver. As the car ran without fault initially and does not overheat. I would think there is a fault with the overcurrent mechanism in the 101bk. As I may be missing the obvious I wondered if you could point to something before I send the 101bk part back for replacement.
Ben Barker
Hello
I recently purchased a Tamiya Hornet kit and it is now fully built. I have had it running for about twenty minutes then whenever I put it in full throttle,either in reverse or forwards it starts jerking/losing signal and will not stop until you ease of the power. I have run through the set up procedure checked batteries connections etc and all things would point to either the TEU-101BK or the Acoms transmitter-receiver. As the car ran without fault initially and does not overheat. I would think there is a fault with the overcurrent mechanism in the 101bk. As I may be missing the obvious I wondered if you could point to something before I send the 101bk part back for replacement.
Regards
Ben Barker